Swapping a Boost 2 Lift Column

Swapping a Boost 2 Lift Column

  1. Remove the motor cover at the base of the lift column: https://youtube.com/shorts/9seddedvczM.
  2. Remove the two bolts that connect the lift column to the handrail: https://youtube.com/shorts/XlumzpQbVOo.
  3. Disconnect lift cable (and console cable, if replacing the user's right hand side lift column) from the lift PCB at the base of the lift column: https://youtube.com/shorts/_Sq81t7hXQY.
  4. (IF APPLICABLE) If replacing the user's right hand side lift column, remove the console cable from the cable channel in the lift column: https://youtube.com/shorts/K6kV7tiHNKA.
  5. Remove the 6 bolts at the base of the lift column that connect the lift to the base: https://youtube.com/shorts/kGIv_OQXcOE. NOTE: Hold the lift column stable during this process as the lift will be free as soon as the hardware is removed.
  6. Remove the lift from the base bracket by lifting it up and out. 
  7. Insert the replacement lift into the base bracket. 
  8. Reinstall the 6 bolts at the base of the lift column that connect the lift to the base: https://youtu.be/1niQMttBMFs. NOTE: Pay close attention to instructions in video to first tighten bolts by hand and using the correct drill clutch setting when tightening bolts. 
  9. (IF APPLICABLE): If replacing the user's right hand side lift column, insert the console cable into the cable channel in the lift column and feed it through the hole in the bottom: https://youtube.com/shorts/nEPle8iByIY.
  10. Reconnect the lift cable (and console cable, if replacing the user's right hand side lift column) to the lift PCB at the base of the lift column: https://youtube.com/shorts/WqBmnuWHOus.
  11. Reinstall the two bolts that connect the lift column to the handrail: https://youtube.com/shorts/KeSUEe5U3cs.
  12. Re-install the motor cover at the base of the lift column: https://youtube.com/shorts/YCShThoC9xE.
  13. Once the lift is fully re-installed, navigate to the home screen on the monitor and use the user's left hand-side knob (bodyweight knob) to move the lift up and down the column, ensuring proper function.

    • Related Articles

    • Greasing lift columns on the Boost 2

      The lift column should be checked periodically by a technician. The lead screw and guide rails in the lift columns need to be greased periodically. Call immediately if there is suspicion of any issues with the lift column. See below for specific ...

    • Lubricating the lift columns on a Boost 2

      While on the home screen of the Boost 2, rotate the bodyweight knob on the left side of the console to move the lift all the way to the bottom of the column. Remove the motor cover at the base of the effected lift column: ...

    • Boost 2 User Manual

      Attached is the Boost 2 User Manual.

    • Boost 2 Installation Manual

      Attached is the Boost 2 Installation Manual.

    • Boost Basics - Getting Started with your Boost 2

      1. Turn on the power, put on the Boost shorts and step inside the treadmill. Helpful Tip #1: Wait to put on your shoes until after the shorts are on to keep your Boost shorts in good condition. Helpful Tip #2: Wear a fitted spandex material such as ...